Performance of adsorbent-embedded heat exchangers using binder-coating method

A. Li, K. Thu, A. Bin Ismail, M.W. Shahzad, K.C. Ng
International Journal of Heat and Mass Transfer, 92, 149-157, (2015)

Performance of adsorbent-embedded heat exchangers using binder-coating method

Keywords

Silica gelwater, Adsorption heat transfer,  Adsorption isotherms,  Binder,  Hydroxyethyl cellulose

Abstract

​The performance of adsorption (AD) chillers or desalination cycles is dictated by the rates of heat and mass transfer of adsorbate in adsorbent-packed beds. Conventional granular-adsorbent, packed in fin-tube heat exchangers, suffered from poor heat transfer in heating (desorption) or cooling (adsorption) processes of the batch-operated cycles, with undesirable performance parameters such as higher footprint of plants, low coefficient of performance (COP) of AD cycles and higher capital cost of the machines. The motivation of present work is to mitigate the heat and mass “bottlenecks” of fin-tube heat exchangers by using a powdered-adsorbent cum binder coated onto the fin surfaces of exchangers. Suitable adsorbent–binder pairs have been identified for the silica gel adsorbent with pore surface areas up to 680 m2/g and pore diameters less than 6 nm. The parent silica gel remains largely unaffected despite being pulverized into fine particles of 100 μm, and yet maintaining its water uptake characteristics. The paper presents an experimental study on the selection and testing processes to achieve high efficacy of adsorbent–binder coated exchangers. The test results indicate 3.4–4.6 folds improvement in heat transfer rates over the conventional granular-packed method, resulting a faster rate of water uptake by 1.5–2 times on the suitable silica gel type.

Code

DOI: 10.1016/j.ijheatmasstransfer.2015.08.097

Sources

Website PDF

See all publications 2015